QNAP QSW
This integration interacts with the local API of QNAP QSW managed switches.
Configuration
To add the QNAP QSW integration to your Home Assistant instance, use this My button:
QNAP QSW can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.
If it wasn’t discovered automatically, don’t worry! You can set up a manual integration entry:
-
Browse to your Home Assistant instance.
-
In the bottom right corner, select the Add Integration button.
-
From the list, select QNAP QSW.
-
Follow the instructions on screen to complete the setup.
Binary Sensors
The following binary sensors are created:
| Binary Sensor | Description |
|---|---|
| anomaly | Device anomaly. |
The following binary sensors are created for each port (or LACP):
| Binary Sensor | Description |
|---|---|
| link | Link status. |
Buttons
The following buttons are created:
| Button | Description |
|---|---|
| reboot | Reboot device. |
Sensors
The following sensors are created:
| Sensors | Description |
|---|---|
| fan_1_speed | Fan 1 Speed. |
| fan_2_speed | Fan 2 Speed. |
| ports | Number of used ports. |
| rx | Total RX bytes. |
| rx_errors | Total number of RX errors. |
| rx_speed | Total RX speed. |
| temperature | Switch temperature. |
| tx | Total TX bytes. |
| tx_speed | Total TX speed. |
| uptime | Uptime seconds. |
The following sensors are created for each port (or LACP):
| Sensors | Description |
|---|---|
| link_speed | Link speed. |
| rx | RX bytes. |
| rx_errors | Number of RX errors. |
| rx_speed | RX speed. |
| tx | TX bytes. |
| tx_speed | TX speed. |
Update
| Update | Description |
|---|---|
| firmware_update | Firmware update status. |