QNAP QSW


This integration interacts with the local API of QNAP QSW managed switches.

Configuration

To add the QNAP QSW integration to your Home Assistant instance, use this My button:

QNAP QSW can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.

URL

Device URL (usually http://IP)

Username

Username (usually admin)

Password

Password

Binary Sensors

The following binary sensors are created:

Binary Sensor Description
anomaly Device anomaly.

The following binary sensors are created for each port (or LACP):

Binary Sensor Description
link Link status.

Buttons

The following buttons are created:

Button Description
reboot Reboot device.

Sensors

The following sensors are created:

Sensors Description
fan_1_speed Fan 1 Speed.
fan_2_speed Fan 2 Speed.
ports Number of used ports.
rx Total RX bytes.
rx_errors Total number of RX errors.
rx_speed Total RX speed.
temperature Switch temperature.
tx Total TX bytes.
tx_speed Total TX speed.
uptime Uptime seconds.

The following sensors are created for each port (or LACP):

Sensors Description
link_speed Link speed.
rx RX bytes.
rx_errors Number of RX errors.
rx_speed RX speed.
tx TX bytes.
tx_speed TX speed.

Update

Update Description
firmware_update Firmware update status.